Frequently Asked Questions About The Retekess TD161 Pager System

We have compiled some common usage questions and answers for the Retekess TD161 pager system. If you have any questions in the process of using the Retekess TD161 pager system, you can refer to this article.

1. How to set pager ID/how to pair/how to add extra pager?

Put the pages on the charging base, press P and 999 (P999 displayed), then press CALL to enter programming mode. The operation must be finished in 20 seconds after pages are charged.

In programming mode, all LED display of the pages will keep flashing.

Then input number and press CALL, all pages display this number. Move the top pager away, the pager will beep once and stop flashing. It means the pager is programmed. Repeat the steps to program other pages.

Note: The pagers will quit programming mode if no operation within 1 minute. All pagers’ numbers will not change if not being programmed.

1 pager only can be programmed 1 number. Old number will be replaced by the new one.

You can also refer to the video in the link below

https://www.youtube.com/watch?v=aSilLY2rgF8

2. How to adjust the reminder mode?

TD161 has two reminder modes. One is normal mode, where the pager will sound, vibrate, flash and beep when called. One is a silent mode where all pagers just vibrate and flash when called.

Press MUTE and 999 (S999 displayed) then press CALL, all charging pagers change to MUTE mode.

Press MUTE and 000 (S000 displayed) then press CALL, all charging pages change to normal mode.

You can also refer to the video at the link below

https://www.youtube.com/watch?v=3owLCHDPs3k